Driveline clunk
#1
Driveline clunk
I have a 2013 V6 convertible, Auto trans, with 3.73's, CAI and Bama Tune. Since installing an Axle Exchange aluminum driveshaft I have a very bad clunk when putting into gear and when it downshifts from 2nd to 1st. It has become more than just annoying, I am concerned there is a problem or it is going to turn into a problem down the road. I called The Axle Exchange and was told #1: the hollow aluminum DS will resinate any driveline sounds, and #2: that there is a known problem with these transmissions and I should get it checked.
Has anyone else experienced this or any suggestions?
Thanks
Steve
Has anyone else experienced this or any suggestions?
Thanks
Steve
#2
IIRC the trans is the TR6060 6-speed, correct? I think thats a pretty stout transmission overall, but anything can fail. Are you lowered? A lowered car may need the pinion angle adjusted so the u-joints dont bind. Did they give you the correct length DS? Also check your control arms, are any bushings worn, or anything loose?
Thread
Thread Starter
Forum
Replies
Last Post