Question for stinger or dan
#1
Question for stinger or dan
Hey guys what type of lugnuts did u guys put on your rtr wheels, the stock ones obviously dont fit, because of the wide lip on the nuts. And the set I put on fit, however I noticed I blew out the cap (err the end) of one of the lugnuts as if the studs are too long.
Can u guys give me any suggestions, on a brand, type or measurement of what your using?
Can u guys give me any suggestions, on a brand, type or measurement of what your using?
#3
#4
Team Mustang Source
Join Date: January 30, 2004
Location: Montreal
Posts: 3,738
Likes: 0
Received 0 Likes
on
0 Posts
I actually removed a wheel just the other day to relocate a spring. It is a bit tight but with a 1/2" deep socket i worked just fine. I obviously didn't use an impact gun.
#5
GTR Member
You could always go with someting like these.
http://www.summitracing.com/parts/GOR-21183HT/?rtype=10
I think they make them in black too.
http://www.summitracing.com/parts/GOR-21183HT/?rtype=10
I think they make them in black too.
#6
Hmmm ok thanks for the info guys, i might try to use the stock ones, i was just being my picky myself and didnt wanna risk damagaing anything.
Althought black ones would be cool too
Althought black ones would be cool too
#8
Update, I actually did end up getting a set of gorilla locks, they fit perfect and look good. As a side note to anyone who may get rtr's or even an aftermarket rims. There these washer like nuts on the rotors, one on each wheel. That almost has a star pattern on them, you wanna absolutlely make sure you take those off.
The stock wheels have a indentation for clearance, so if u dont take those off, the wheel wont be flat, and your gonna have a safety issue on your hands, and a ton of vibration in the wheel. Pat @ classic design concepts was able to help me out with this problem, hes the man.
The stock wheels have a indentation for clearance, so if u dont take those off, the wheel wont be flat, and your gonna have a safety issue on your hands, and a ton of vibration in the wheel. Pat @ classic design concepts was able to help me out with this problem, hes the man.
Last edited by Praetorian730; 8/21/10 at 08:34 AM.
#9
I actually already had them on my black bullitts and then just transfered them over. I didn't want shiny lug nuts on these wheels.
I'm glad your wife let you keep the wheels Praetorian.
Thread
Thread Starter
Forum
Replies
Last Post